If any drive in the array f ails, all data is lost. When connecting with wires onto c onnectors, please note that the red wire is the positive and should be c onnec ted to pin 2, and the blac k wire is Gr ound and should be connected to GND. This function allows user to adjust Memory voltage. Wait f or f ive seconds. Floppy Disk Conne ctor The motherboard prov ides a standard floppy disk connector that supports K, K, 1.
|Date Added:||27 May 2012|
|File Size:||66.84 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Biostar NFA2 SE Owner’s Manual |
Should one driv e f ail, the controller switches to the other drive. When you see the etbernet dialog in setup procedure, it means setup is completed.
Dual Channel Memory installation To mf520-a2 the Dual Channel function of the motherboard, the memory module must meet the following requirements: Look for the white triangle on socket, and the gold triangle on CPU should point forwards this white triangle.
The following figures are only for reference, the screen printed in this user manual will change according to your motherboard on hand. Memory Modules 10 1. Remov e AC power line. Keyboard lights Using even pressure on both ends of are on, power indicator lights are lit, the DIMM, press down firmly biostra the and hard driv e is spinning.
Then system will do fail-safe reboot by using Watchdog function.
Make sure both ends viostar securely plugged in; check the driv e type in the standard CMOS setup. This PCI slot is designated as 32 bits.
Biostar NF A2 – motherboard – ATX – Socket AM2 – nForce Overview – CNET
The mirrored backup copy of the data can reside on the same disk or on a second redundant drive in the array. Minimum 4, and maximum is 6 or 8, depending on the platform.
Power on the system again. Call the drive manuf acturers f or compatibility with other drives. The fan cable and connector may be different according to the fan manufacturer.
No capacity loss penalty f or parity. Plug in the power cord and boot up the system. It will disable the output on back nf50-a2 audio connectors. It breaks up a large file into smaller blocks and performs disk reads and writes across multiple drives in parallel. When connecting with wires onto c onnectors, please note that the red wire is the positive and should be c onnec ted to pin 2, and the blac k wire is Gr ound and should be connected to GND.
Hardware Monitor Panel Click the Hardware Monitor button in Main Panel, the button will be highlighted and the Hardware Monitor panel will show up as the following figure. Remove the power cord from power supply for seconds. System does not boot from hard disk 1. As you can see, the Overclock Panel is on the right side, and the Overvoltage Panel is on the left side. All the brand and produc t names are trademarks of their respec tive companies.
Every read and write is actually carried out in parallel across 2 disk drives in a RAID 1 array system. The vendor makes no representations or warranties with respec xe to the contents here and s pecially disclaims any implied warranties of merchantability or fitness for any purpose.
Loose parts will cause short circuits which may damage the equipment.
Wait f or f ive seconds. Connect the fan cable to the connector while matching the black wire to pin 1.
Requires 2 driv es for the storage space of one driv e. Data transfer rates up to 3.
Biostar NF520 A2 – motherboard – ATX – Socket AM2 – nForce 520
All hard disks are capable of breaking down at any time. Pull the lever toward direction A from the socket and then raise the lever up to a degree angle. When the CPU is over heated, the motherboard will shutdown automatically to avoid a damage of the CPU, and etbernet system may not power on again.