It checks the tape format such as DDS-2 or audio and the number of partitions. In Stacker mode, cartridges are used sequentially from the autoloader magazine. Note If you decide to leave a cleaning cartridge permanently in the magazine, it will reduce the amount of data you can back up to the magazine, since you will only have five slots available for data cartridges. Load Tape Button Use the Load Tape button to load the selected cartridge from the magazine into the drive. When I click on properties and then select the additional information tab it says “No configuration device file exists”.
|Date Added:||20 December 2012|
|File Size:||49.52 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The problem could lie with the cartridge: Hi All, I am quite new to netbackup and devife this forum, my first post. All SCSI devices must support asynchronous transfer.
If you press the Unload button when the drive is busy, it may be a long time before the drive will respond to the request, because it must first finish the task on which it is engaged. Find More Posts by michaelk.
Solved: Unable to configure HP Storageworks DAT 40 (DDS4) – VOX
E F Cleaning failed, possibly due to an expired tape. Has there been dust or dirt near the drive. If a fault has been detected with the mechanism, or loss of data may result, the error message may be accompanied by the Operator Attention Required light being lit or flashing. Please help us maintain a ecsi driver collection. No maintenance is necessary apart from regular cleaning of the tape heads. These extra methods of error detection and correction are as follows: The firmware upgrade process has been successfully completed.
Because forced ejection may interrupt any operation, it is possible that the drive will not write EOD before the cartridge is ejected.
As a result, the entire eject sequence can take between 30 seconds and 2 minutes. After that, a drive will reformat it for normal data use, although given the amount of use it will have had, it is not advisable to use it for data.
With both autoloaders, an expired cleaning cartridge will be ejected in less than 20 seconds instead of the usual 30 seconds. Inclusion of supported Mode and Log pages p.
Join our community today! The problem could lie with the host or the software. However, in the “limitations” field it says yes, see properties.
The following sequence of events occurs: Blocks are numbered sequentially, starting with 1 at BOM. If you load a cartridge which is not DDS Media Recognition System, the cartridge will be treated as write-protected; you will only be able to read it, not write to it. For early versions of the firmware, the Tape log is not updated on unloading. HP drives can be configured to treat non-MRS tapes as write-protected.
Re: Detection of a SCSI scanner
The autoloader will then automatically upgrade the firmware. Retries Limits on Rewrites Fevice Read-After-Write rewrites, each frame can be rewritten up to a maximum of times giving writes of the frame. All tests complete successfully. You can use a combination of Ultra and Ultra2 devices. The HP CA has a TapeAlert feature that allows software and operating systems to warn users of problems which may occur, such as a cartridge nearing the end of its useful life, and to recommend actions that the user can take to recover from the situation.
If this matches its hardware, the drive will update devics firmware.
If you connect only LVD devices, the bus will operate in low voltage differential mode and Ultra2 speeds will be enabled. The two main activities are to clean the heads regularly, and to avoid condensation and temperature extremes. This takes a maximum of 25 seconds from the time the cartridge is inserted to the time the drive is ready to start acting upon the next command from the host.
As a guideline, a typical 80mm 3 in square fan in a system box produces 0.